Putting Into Operation - Abicor Binzel ABITIG WH Betriebsanleitung

6 Putting into operation

6 Putting into operation
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the coolant supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTE
• Only qualified personnel are permitted to perform work on the device or system.
• Note the following instructions
 3 Product description on page EN-5
6.1 Equipping the TIG welding torch
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone.
• Wear the correct protective gloves.
NOTE
• The torch equipment depends on the material to be welded. The required amperage
determines the electrode diameter. Please see the current order documents for a correct
selection of the equipment parts.
• Instead of the electrode holder, you may also use a gas diffuser that produces a laminar
gas flow due to its design.
EN - 10
®
ABITIG WH
BAL.0111 • 2019-06-19