Additional Functions; Setting The Arc Characteristic; Adjusting The Iarc Mx Speed Penetration Control; Adjusting The Move Frequency - Abicor Binzel iROB 501 Originalbetriebsanleitung

® ®
iROB 501, iROB 401, iROB

7.4 Additional functions

7.4.1 Setting the arc characteristic

Use of this function makes it possible to adjust the arc from hard (−10) to soft (+10).

7.4.2 Adjusting the iArc mX Speed penetration control

Activating this function makes it possible to automatically adjust the wire feed speed so that the welding
current remains constant even if the free welding wire end varies. The variances in penetration depth and
seam width are reduced. This function facilitates a consistent penetration depth.
iArc mX Speed penetration control is available under the following conditions:
— Welding procedure: iArc mX Standard DC or iArc mX DC
— Welding wire material: Steel, steel filler wire, CrNi stainless steel, or stainless steel filler wire
— Sequence: Main welding sequence

7.4.3 Adjusting the move frequency

The welding current switches between two values during the iArc mX Move DC welding procedure.
This creates a scaled seam surface, the markedness of which is influenced by the frequency.
The move frequency function is only available in the iArc mX Move DC welding procedure.
®
301
ARC DYN.
P.CONTR.
Move
Move
Press the <Arc control> button.
1
The value is displayed in the left digital display.
Set the arc characteristic with the <Parameter setting>
2
knob.
Press the <Penetration control> button.
1
The LED above the button illuminates.
Press the <Move-frequency> button.
1
f
The selected sequence's LED illuminates.
The set value for the move frequency is displayed in
the left digital display.
Use the <Parameter setting> knob to set the desired value.
2
Press the <Move-frequency> or <Parameter selection>
3
f
button.
The setting has been made.
7 Operation
EN - 33