Overview Of Welding Procedures - Abicor Binzel iROB 501 Originalbetriebsanleitung

® ®
iROB 501, iROB 401, iROB
Tab. 10
Function
End crater filling
Shielding gas type
Welding wire material
Welding procedure
Welding wire diameter (mm)
Start parameter
Voltage adjustment
Penetration control

7.2.2 Overview of welding procedures

The possible combinations of welding procedures are listed in the following tables and can be selected by
the connected robot via the interface. If an impermissible combination is selected, this is indicated in the
right/left blinking digital display <−>.
The welding procedures produce high-quality welding results only with the specified shielding gases and
shielding gas combinations. Changes to the shielding gases and shielding gas combinations always affect
the welding results.
Tab. 11
Welding procedures (standard)
Welding Shielding
procedure gas type
iArc mX Standard DC 100% CO
82% Ar + 18% CO
92% Ar + 8% CO
98% Ar + 2% O
97.5% Ar + 2.5% CO
100% Ar
®
301
Functions
Steel, steel filler wire, stainless steel, ferritic stainless steel,
iArc mX Standard DC, iArc mX Pulse DC, iArc mX Clean
Welding wire
material
Fe
2
Fe(Fill)
CrNi(Fill)
Fe
2
Fe(Fill)
CrNi(Fill)
Fe
2
CrNi
2
CrNi(Ferr)
CrNi
2
CrNi(Ferr)
AlSi5/12
AlMg5
CuSi3
CuAl8
Adjustable parameters
End crater filling OFF
End crater filling ON (without pulse)
End crater filling ON (with pulse)
CO MAG (18% CO
2
MAG (8% CO
2
MIG (2% O )
2
MIG (2.5% CO
2
MIG (100% Ar)
MIG (30% He)
stainless steel filler wire, CuSi, CuAl, Al99, AlMg5,
AlMg4.5Mn, AlSi5/12, Ni base, titanium
®
(not available for iROB 301), iArc mX Move DC
0.8 / 1.0 / 1.2 /
1.6 (not available for iROB
ON/OFF
Arc length correction/manual
ON/OFF
Welding wire Welding
diameter (mm) speed
1.6 mm not available
®
for iROB 301
0.8/1.0/1.2 High/standard
1.6 (not available for
®
iROB 301)
1.2/1.6 Standard
1.2/1.6 Standard
0.8/1.0/1.2/1.6 High/standard
1.2/1.6 Standard
1.2/1.6 Standard
0.8/1.0/1.2 High/standard
0.8/1.0/1.2/1.6 High/standard
0.8/1.0/1.2 High/standard
0.8 / 1.0 / 1.2 / 1.6 High/standard
0.8/1.0/1.2 High/standard
1.2/1.6 Standard
1.0/1.2/1.6 Standard
0.8/1.0/1.2 Standard
0.8/1.0/1.2 Standard
7 Operation
)
2
)
)
®
301)
Penetration
control
Possible
Possible
Possible
Possible
Possible
Possible
Possible
Possible
Possible
Possible
Possible
–
–
–
–
EN - 27