Abicor Binzel iROB 501 Originalbetriebsanleitung Seite 150

13 IFR-800 fieldbus connection tool
Tab. 29
Byte
18
18
19–20
21
21
22–23
24
24
25–26
27
27
28–29
Tab. 30
Fault code
30–59
100
900–912
Tab. 31
Setting
0
1
2
3
Tab. 32
Setting
0
1
2
3
Tab. 33
Setting
0
1
2
3
4
5
6
7
EN - 70
Details of output data
Bit Function
0–6 Function (port 1) no. Settings other than offsets 4 to 17 are specified here. There
are 4 setting ports, so up to 4 settings can be changed at
7 Function (port 1)
the same time.
display change
Specifies the setting element by function number. When set
– Function (port 1)
to 0, there is no data. Settings from 1 to 99 specify the
setting value
internal function with the same function number.
0–6 Function (port 2) no.
 7.5 Setting internal functions on page EN-34
7 Function (port 2)
In addition, other functions are available.
display change
 7.4 Additional functions on page EN-33
– Function (port 2)
Indicates the setting value of the element specified by the
setting value
function number of the function setting value. For ON/OFF
0–6 Function (port 3) no.
settings, 1 is ON and 0 is OFF.
7 Function (port 3)
When the display change of the function is set to 1 and a
display change
function that supports display change is selected, the value
– Function (port 3)
after the display change becomes the function setting of the
setting value
input data. However, the setting method (value range) of the
0–6 Function (port 4) no.
function setting value of the output data is not changed from
the method before the display change. Functions 60 to 65
7 Function (port 4)
support a display change.
display change
 F60: Fine adjustment of the pulse peak current on
– Function (port 4)
setting value
Fault codes that cannot be remedied through communication control
Setting the travel speed
Setting the welding procedure
Setting the shielding gas type
®
iROB 501, iROB
Description
page EN-44
Description
System error
Control voltage error
System error
Travel speed
Standard
High
Option
Option
Welding procedure
iArc mX Pulse DC
iArc mX Standard DC
iArc mX Clean
®
(not available for iROB
iArc mX Move DC
Shielding gas type
CO
2
80/20 ArCO
2
98/2 ArO
2
Ar
90/10 ArCO
2
97.5/2.5 ArCO
2
70/30 ArHe
Option
® ®
401, iROB 301
301)