Abicor Binzel iROB 501 Originalbetriebsanleitung Seite 155

® ®
iROB 501, iROB 401, iROB
Tab. 39 Function numbers
No. Function name
111
End crater current
112
End crater feed speed
113 End crater voltage
114 Fine adjustment of end crater
voltage for synergetic mode
121 Determine device number
122 Determine software number
123 Determine major version
124
Determine minor version 1
125
Determine minor version 2
126
Determine upgrade version
®
301
Adjustable
range
20–550
4–180
100–500
−100–100
–
–
–
–
–
–
13 IFR-800 fieldbus connection tool
Specified Description
value
100 Sets the current in the end crater condition.
The unit for this setting is [1 A]. This setting is
valid only when the special end crater filling
sequence function (F45) is ON and the wire
feed speed setting from offset 8/bit 1 is "0".
12 Sets the wire feed speed in the end crater
condition. The unit for this setting
is [0.1 m/min.]. This setting is valid only when
the special end crater filling sequence function
(F45) is ON and the wire feed speed setting
from offset 8/bit 1 is "1".
215 Sets the voltage in the end crater condition.
The unit for this setting is [0.1 V]. This setting is
valid only when the special end crater filling
sequence function (F45) is ON and the voltage
setting for synergetic mode from offset 8/bit 0
is "0".
0 Performs fine adjustment of the end crater
voltage for synergetic mode. This setting is valid
only when the special end crater filling
sequence function (F45) is ON and the voltage
setting for synergetic mode from offset 8/bit 0
is "1".
– Software information about the device can be
determined using input data. The setting value
–
of the output data is disabled.
–
The serial number of the device and the
–
software number are indicated by numeric
–
characters (without letters).
–
Example 1: "30125" is defined for "P30125".
Example 2: "7360" is defined for "K7360".
EN - 75