Trend For Changes - NeurOptics NPi-300 Pupillometer Gebrauchsanweisung

Press and hold either the RIGHT or LEFT button
until the pupil is centered on the touchscreen
and the display shows a green circle around the
pupil. A green frame around the screen indicates
the pupil is properly targeted (Ex. 21), while a red
frame indicates the pupil needs to be re-centered
on the screen before the measurement is initiated
(Ex. 22). Once the green frame appears, release the button, holding the NPi-300 in place for approximately
three seconds until the results screen is displayed.
Repeat the scan procedure for the patient's other eye to complete the bilateral pupil exam. When the bilateral
pupil exam is complete, the NPi-300 measurement results will be displayed in green for the Right eye and in
yellow for the Left eye.
The NPi-300 is defaulted to open "Results Page 1,"
displaying NPi and Size measurements, following
the completion of the Bilateral Pupil Measurement
(Ex. 23). To adjust Default Results Page Settings,
see NPi-300 Pupillometer Navigation Guide.
Using the touchscreen or keypad, select
view "Results Page 2" with additional Pupillary
Measurement Parameters (Ex. 23). Select
view the Pupillary Light Reflex Waveform (Ex. 24).
To return to "Results Page 1" with NPi and Size,
simply select (Ex. 25).
Video Replay
From the Results screen, select the Video icon
to view the video playback of the reading. Only the
last measurement's video can be played back. Once
the NPi-300 has powered off, the last video is not
accessible (Ex. 26).

3. Trend for Changes

To review the patient's previous bilateral pupil measurements stored on the
attached SmartGuard and Trend for Changes:
• If still on the Results Page following completion of the last measurement:
Press the DOWN Arrow button
• From the Home Screen: Select the Records icon
SmartGuard icon
first. Press the DOWN Arrow button
previous patient measurements stored on the attached SmartGuard.
Browse Records
To review records stored on the NPi-300 if the patient's SmartGuard is unavailable:
From the Home Screen: Select the Records icon
•
• To browse records by Patient ID, select the ID from the list or use the UP
and DOWN arrows on the screen to browse additional ID's available in
the list. The ID's of the most recent measurements taken on the NPi-300 will
appear at the top of the list.
• To search for a specific Patient ID, select
Patient ID and select
• To browse all pupil measurements stored on the NPi-300 in chronological
order (including all Patient ID's), select the All Records icon
and press the DOWN Arrow button
previous measurements stored on the NPi-300.
• When the No more records message appears, the earliest pupil measurement
stored has been reached (Ex. 29).
NeurOptics® NPi®-300 Pupillometer System—Instructions for Use ©2021 NeurOptics, Inc.
to
to
on the keypad.
(Ex. 28). The most recent measurement will appear
on the keypad to scroll through all
.
on the keypad to scroll through all
(Ex. 27), then select the
(Ex. 27).
(Ex. 28), then type in the
(Ex. 28)
Ex. 21
Ex. 23
Ex. 25
Ex. 22
Ex. 24
Ex. 26
Ex. 27
Ex. 28
Ex. 29
7