EDELRIDe VECTOR CHEST X Bedienungsanleitung Seite 27

the instructions for use of the rope clamp accordingly
and never use without back up. Compatibility and func-
tion need to be checked in a safe place before actual
use. Attention: metal can damage the webbing, check for
damages on webbing, sharp edges or burrs on metal. Do
not use without anti-twist.
9. INSTALLATION OF ACCESSORIES
a) Workseat: The work seat loops (F) are meant exclusive-
ly for use in connection with a work seat. The selection of
suitable connectors is the responsibility of the user.
b) Tool clip holder: Max. 25 kg. c) Tool bag attachment.
10. LANYARD PARKING ELEMENT
If Y-type lanyards are used in conjunction with an energy
absorber, the energy absorber may not work in case one
branch of the lanyard is connected to the attachment
point and the second branch to a load bearing part of the
harness. Therefore, it is recommended to attach the sec-
ond branch to the climbing harness by means of tear-off
loops (L).
11. SIZE CHART
12. CLIMATE REQUIREMENTS
SERVICE LIFE AND REPLACEMENT
The service life of the product mainly depends on the
type and frequency of use as well as on external influenc-
es. When approaching the durability limits or at the end
of the maximum service life indicated, the product must
be removed from use. Products made of synthetic fibres
(Polyamid, Polyester, Dyneema
subject to some aging even if not used; their service life
especially depends on the intensity of the ultraviolet ra-
diation and other climatic conditions they are exposed
to. When approaching the durability limits or the end of
the maximum service life indicated, the product must be
removed from use.
Material: PA, PES, Aluminium, Steel
Maximum service life
Textile parts: with optimum storage conditions and with-
out use: 14 years.
Metal parts: Unlimited.
, Aramid, Vectran ) are
® ®
Maximum lifetime in use
Textile parts: providing proper use and no detectable
sign of wear showing as well as under optimum storage
conditions: 10 years.
Metal parts: Unlimited
Frequent use or extremely high loading may substantially
reduce the useful life.
Therefore, before use, check the product for possible
damages and correct function If any of the following ap-
plies remove the product from service immediately and
turn it over to a qualified person or the manufacturer for
inspection and/or repair including a written confirma-
tion, before using it again (list non-exhaustive):
- if there are doubts concerning safe use;
- if sharp edges have the potential to damage the rope of
hurt the user;
- if visible signs of damage material (e.g. cracks, plastic
deformation);
- if the material shows deep corrosion;
- if the product was exposed to extreme temperatures
- if the material has come in contact with chemicals
- if the load bearing straps had contact with a sharp edge
- if the product has been subjected to a hard fall load or
high shock loads occurring in a pendulum fall
- if the karabiner gate does not shut fully and/or auto-
matically.
Inspection and documentation
In case of commercial use, the product must be inspect-
ed regularly or at least once a year by the manufacturer,
a qualified person or an approved inspection body/
agency; thereafter it may have to be serviced or removed
from use. Legibility of the markings has to be checked.
Such inspections and service must be documented for
each product. The following information must be record-
ed: Product identification and name, manufacturer's
name and contact details, unique identification, date of
manufacture, date of purchase, date of initial use, date of
next regular inspection, result of inspection, and signa-
ture of qualified person responsible. A suitable specimen
is found at www.edelrid.de