Battery Charge Level; Potential Equalization Conductor - allen Advance Table Bedienungsanleitung

Instructions for Use
–
Plug the power cord into the Allen
Advance Table outlet and into an
applicable power outlet.
NOTE:
When the Allen Advance Table is plugged
in, the Power indicator will be on.
–
Press the On/Off switch to the applicable position:
I = On
O = Off
NOTE:
When the On/Off switch is on and the Allen Advance Table is not
plugged into a power outlet, the Allen Advance Table operates on
battery power. Battery power is for short term use only and should be
used for emergency power situations only.

Battery charge level

WARNING:
If the batteries are not charged before you use the
Allen Advance Table , the Allen Advance Table may
not function in an emergency. Patient fall or injury
could occur.
When the Battery Charge Level indicator shows a low
level of charge or if you hear a "beep" from the Allen
Advance Table when you try to use the pendant controls, plug the Allen
Advance Table into an applicable power outlet to charge the batteries. To
keep the batteries charged, plug the Allen Advance Table into an outlet
nightly and when you store the Allen Advance Table.
NOTE:
A "beep" from the Allen Advance Table indicates that the battery
charge level is low or depleted.
NOTE:
When the Allen Advance Table is not plugged in: the Battery Charge
Level indicator will be on when the On/Off switch is on; the Battery
Charge Level indicator will be Off when the On/Off switch is Off.

Potential Equalization Conductor

There is a plug on the Allen Advance Table for connecting an equipotential
bonding cable. This will equalise any potential difference when the Allen
20 Allen® Advance Table User Manual (80028190)
On/Off switch