The Pendant Control And Manual Flip Indicators Are Flashing; The Brakes Locked And Unlocked Indicators Are Flashing; The Allen Advance Table "Beeps" When Apendant Control Is Pressed; Service Calls - allen Advance Table Bedienungsanleitung

SERVICE CALLS

THE PENDANT CONTROL AND MANUAL FLIP
INDICATORS ARE FLASHING
Make sure that the flip handle is fully in the up and locked position or
down and released position. If the indicators continue to flash, reset the
power: press the On/Off switch to off and then to on.
THE BRAKES LOCKED AND UNLOCKED
INDICATORS ARE FLASHING
Press and hold either the Lock or Unlock Brakes pendant control until the
applicable Brakes locked/unlocked indicator on the display stays on; the
indicators are no longer flashing.
THE ALLEN ADVANCE TABLE "BEEPS" WHEN A
PENDANT CONTROL IS PRESSED
A "beep" from the Allen Advance Table lets you know that the battery
charge level is low or depleted. Plug the Allen Advance Table into an
applicable power outlet to charge the batteries. To keep the batteries
charged, plug the Allen Advance Table into an outlet nightly and when you
store the Allen Advance Table.
SERVICE CALLS
When you call Allen Medical about your unit, be prepared to give the serial
number from the product identification label. You will find the label on the
inside of the head-end base near the on/off switch.

PREVENTIVE MAINTENANCE

WARNING:
Only Allen Medical-authorised persons should service the Allen Advance
Table. Service by unauthorized persons could cause patient fall, injury, or
equipment damage.
We recommend that you do annual preventive maintenance on the Allen
Advance Table. An effective way to reduce downtime and make sure the
Allen Advance Table operates correctly is to do preventive maintenance.
The suggested Maintenance Checks below include specific items for you to
examine.

MAINTENANCE CHECKS

If any of these checks fail, repair or replace the part as applicable. If any of
these checks fail, repair or replace the part as applicable. If the repair or
replacement does not correct the problem, remove the unit from service and
44 Allen® Advance Table User Manual (80028190)