HIKOKI C 10RJ Bedienungsanleitung Seite 39

the motor to cool down for at least five minutes. And press the
overload reset switch button to resume the overload switch. After
the motor has cooled down, press the green "I"-button on the
ON/OFF switch to restart saw.
Working table
Surface where the workpiece rests while performing a cutting
operation.
Kerf
The material removed by the blade in a through-cut, or the slot
produced by the blade in a nonthrough or partial cut.
Push Stick
A push stick should be used for narrow ripping operations when
the fence is 150 mm or less from the blade. These aids help to
keep the operator's hands well away from the blade.
Kickback
A hazard that can occur when the blade binds or stalls, throwing
the workpiece back toward the operator.
Ripping or Rip Cut
A cutting operation along the length of the workpiece.
Bevel Cut
A cutting operation made with the blade at any angle other than
90° to the table surface.
Compound Cut
A crosscut made with both a mitre angle and a bevel angle.
Crosscut
A cutting or shaping operation made across the grain or width of
the workpiece.
Mitre Cut
A cutting operation made with the workpiece at any angle other
than 90° to the blade.
Non-Through Cut
Any cutting operation where the blade does not extend complete-
ly through the thickness of the workpiece.
Through-sawing
Any cutting operation where the blade extends completely
through the thickness of the workpiece.
Freehand
Performing a cut without the workpiece being guided by a fence,
mitre gauge, or other aid Never perform any cut freehand with
this saw.
SYMBOLS
WARNING
The following show symbols used for the machine. Be
sure that you understand their meaning before use.
C 10RJ (X): Table saw
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Always wear hearing protection.
Danger keep hands away from blade.
Never operate the tool in a damp or wet
environment.
Lock / to tighten or secure.
Unlock / to loosen.
Caution, Warning or Danger.
V Volts
Hz Hertz
A Amperes
n
o No load speed
---/min Revolutions per minute
W Input power
kg Kilogram
dB(A) Decibel (A-rated)
~ Alternating current
Class II Construction
The product complies with the applicable
European directives and an evaluation method
of conformity for these directives was done.
Only for EU countries.
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/
EU on waste
equipment
accordance with national law, electric tools that
have reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling facility.
39
English
electrical and electronic
and its implementation in