Herunterladen Inhalt Inhalt Diese Seite drucken

Suzuki VZ1600K4 Montageanleitung Seite 25

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

WARNING
Operation with improperly routed, or
damaged throttle cables could result in
an unsafe riding condition.
Check for any exhaust leaks and correct if
necessary.
Headlight Aim
The headlight beam is adjustable both hori-
zontally and vertically. Headlight aim must be
correctly adjusted for safe riding as well as on-
coming drivers. In most areas it is illegal to ride
with an improperly adjusted headlights.
Horizontal Adjustment
Turn the horizontal adjusting screw on the
headlight rim in or out until the beam points
straight ahead.
A. Vertical Adjusting Screw
B. Horizontal Adjusting Screw
Vertical Adjustment
Turn the vertical adjusting screw on the head-
light rim in or out to adjust the headlight verti-
cally.
NOTE
On high beam, the brightest point should be
slightly below horizontal with the motorcycle
on its wheels and the rider seated. Adjust
the headlight to the proper angle according to
local regulation.
Fastener Check
Check all the fasteners specified in this man-
ual and tighten as required. Also check to see
that each cotter pin or safety clip is in place
and in good condition.
[Tightening Torque]
Frame/Steering:
Handlebar mounting nuts:
34 N·m (3.5 kgf·m, 25 ft·lb)
Steering stem head nut:
88 N·m (9.0 kgf·m, 65 ft·lb)
Steering stem nut:
4.9 N·m (0.50 kgf·m, 43 in·lb)
Brake:
Brake bleed valves:
7.8 N·m (0.80 kgf·m, 69 in·lb)
Brake hose banjo bolts:
25 N·m (2.5 kgf·m, 18 ft·lb)
Front master cylinder clamp bolts:
8.8 N·m (0.90 kgf·m, 78 in·lb)
Rear master cylinder mounting bolts:
25 N·m (2.5 kgf·m, 18 ft·lb)
Caliper mounting bolts (Front & Rear):
34 N·m (3.5 kgf·m, 25 ft·lb)
Brake disc mounting bolts (Front & Rear):
27 N·m (2.8 kgf·m, 20 ft·lb)
Wheel:
Front axle:
108 N·m (11 kgf·m, 80 ft·lb)
Front axle clamp bolts:
29 N·m (3.0 kgf·m, 21 ft·lb)
Rear axle nut:
108 N·m (11 kgf·m, 80 ft·lb)
Suspension:
Front fork clamp bolts (Upper & Lower):
29 N·m (3.0 kgf·m, 21 ft·lb)
Rear shock absorber nuts (Upper &
Lower):
34 N·m (3.5 kgf·m, 25 ft·lb)
Swingarm pivot shaft:
108 N·m (11 kgf·m, 80 ft·lb)
- 23 -

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis