Suzuki VZ1600K4 Montageanleitung Seite 9

A. Pump the fork up and down.
•
Tighten the axle clamp bolts on the right fork
leg to the specified torque.
Torque: 29 N·m (3.0 kgf·m, 21 ft·lb)
•
Check the clearance between the right fork
leg and the axle collar with the thickness
gauge. There should be about 2.0 mm (0.08
in.) of clearance. The clearance between
1.05 ~ 3.19 mm (0.04 ~ 0.13 in.) is accept-
able.
A. Axle Clamp Bolts
B. About 2.0 mm (0.08 in.)
C. Axle Collar (Right)
D. Right Fork Leg
E. Front Axle
•
If the clearance is out of this range, remove
the front wheel again and check the axle,
wheel hub and other related parts for dam-
age.
•
Tighten both front brake caliper mounting
bolts to the specified torque.
Torque: 34 N·m (3.5 kgf·m, 25 ft·lb)
•
Check the front brake.
A. Front Brake Caliper (Left)
B. Bolts
Do not attempt to drive the motorcycle
until a full brake lever is obtained by
pumping the brake lever until the pads
are against the disc. The brake will not
function on the first application of the
lever if this is not done.
Front Brake Hose Clamps
(Left and Right)
Brake Hose Clamp (Left)
•
Fit the plastic hose clamp onto the front brake
hose (left) and push its end into the hole in the
left side of the front fender.
A. Clamp (Plastic)
B. Brake Hose (Left)
Brake Hose Clamp (Right)
•
Fit the clamp onto the front brake hose (right)
and push its end into the hole in the right side
of the fender.
- 7 -
WARNING
C. Front Fender