Suzuki VZ1600K4 Montageanleitung Seite 17

A. Bottom Thread
•
If the oil level is too high, remove the excess
oil, using a syringe or some other suitable
device.
WARNING
Be careful that no oil gets on the tire, rim,
and brake disc. Clean off any oil that
inadvertently gets on them with oilless
solvent.
CAUTION
Be careful not to allow any dirt or foreign
materials to enter the gear case.
NOTE
○
Use the same type and brand of oil that is
already in the final gear case.
•
When replacing the filler cap, be sure the O
-ring is in place, and install the cap.
Final Gear Case Oil
Type: API "GL-5"
Hypoid gear oil
Viscosity: SAE 90 [above 5°C (41°F)]
SAE 80 [below 5°C (41°F)]
Capacity: 0.2 L (0.21 US qt)
Final Gear Case Oil Drain Plug Torque:
8.8 N·m (0.90 kgf·m, 78 in·lb)
Front Brake Fluid
Front Brake Fluid Level Inspection
•
With the front brake fluid reservoir held hori-
zontal, check that the fluid level is above the
lower level line.
B. Filler Cap A. Front Brake Fluid Reservoir
B. Lower Level Line
•
If the fluid level in the reservoir is lower than
the lower level line, check for fluid leaks in the
front brake lines, and fill the reservoir.
•
Loosen the screws to remove the front brake
fluid reservoir cap and diaphragm.
•
Fill the reservoir to the upper level line with
DOT4 brake fluid.
reservoir is a stepped line showing the upper
level line.
A. Front Brake Fluid Reservoir
B. Upper Level Line
- 15 -
Inside the front brake