NOTE
○
Charging rates will vary depending on how
long the battery has been stored, tempera-
ture, and the type of charger used. Let battery
sit 30 minutes after initial charge, then check
voltage using a voltmeter. If it is not at least
12.6 volts, repeat charging cycle.
NOTE
○
To ensure maximum battery life and customer
satisfaction, it is recommended the battery be
load tested at three times its amp-hour rating
for 15 seconds.
Re-check voltage and if less than 12.6 volts
repeat the charging cycle and load test. If still
below 12.6 volts the battery is defective.
Battery Installation
•
Turn the ignition switch OFF.
•
Apply a light coat of grease to the battery ter-
minals to prevent corrosion.
•
Place the battery into the battery case.
•
Pull the battery positive cable (+) downward
and through the guide in the right side of the
battery case, and then route the cable as
shown.
A. Negative Cable (–)
B. Positive Cable (+)
C. Battery Holder
D. Plastic Clamp
E. Battery
F. Run the positive cable (+) downward
and through the guide in the
right side of the battery case.
•
Connect the red capped positive cable to the
positive (+) terminal first, and then connect
the black capped negative cable to the neg-
ative (−) terminal.
•
Cover the battery terminals with their protec-
tion rubber caps.
•
Insert the 6P connector (white) into the holder.
•
Reinstall the battery holder with the bolts (2).
A. Battery Terminal (+)
B. Positive Cable (+)
C. Negative Cable (−)
D. 6P Connector
E. Plastic Clamp
F. Battery Holder
G. Main Fuse
H. Negative Lead Connector
I. Fuel Pump Connector
J. Connector (Diagnosis)
•
Install the seat in the reverse order of re-
moval.
•
To install the seat, insert the projection at the
front of the seat into the receptacle on the
frame, and tighten the bolts.
A. Projection
- 13 -
B. Receptacle