Idle Speed Adjustment - Suzuki VZ1600K4 Montageanleitung

A. Tire Air Pressure Gauge
Coolant
Coolant Level Inspection
•
Situate the motorcycle so that it is perpendic-
ular to the ground.
•
Check the coolant level through the coolant
level gauge. The coolant level should be be-
tween the F (Full) and L (Low) marks.
NOTE
○
Check the level when the engine is cold (room
or atmospheric temperature).
A. F (Full) Mark
B. L (Low) Mark
Coolant Filling
•
If the amount of coolant is insufficient, remove
the right side cover, pull open the cap from the
reserve tank and add coolant through the filler
opening to the F (Full) mark.
C. Right Side Cover
A. Cap
B. F (Full) Mark
•
Install the cap and right side cover.
○
A permanent type of antifreeze is installed in
the cooling system when shipped. It is col-
ored green and contains ethylene glycol. It is
mixed at 50 % and has the freezing point of –
35°C (– 31°F).

Idle Speed Adjustment

•
Start the engine and warm it up thoroughly.
•
Adjust the idle speed to 900 ~ 1 000 r/min
(rpm) by turning the idle adjusting screw.
Idle Speed: 900 ~ 1 000 r/min (rpm)
A. Idle Adjusting Screw
•
Open and close the throttle grip a few times
to make sure that the idle speed does not
change.
•
With the engine idling, turn the handlebar to
each side. If handlebar movement changes
the idle speed, check the throttle cable routing
and free play.
- 22 -
C. L (Low) Mark
NOTE