5B
4B
1B
Premontare i n.2 gommini (5B) sulla staffa (9B). Inserire la rosetta
in ottone (7) nell'apposito vano, come mostrato in figura. Accop-
piare la vite (3B), il faretto (1B), la rosetta (6B) e la staffa (9B) man-
tenendo l'esatta sequenza rappresentata in figura. Impuntare dal-
la parte opposta della staffa (9B) il dado (4B) fino a battuta, senza
serrare. Premontare sulla staffa destra (11) i n.2 gommini (15B).
16
16
15B
9B
7
6B
Pre-fit no.2 rubber elements (5B) on bracket (9B). Fit brass washer
(7) inside the special compartment as shown in the figure. Couple
screw (3B), spotlight (1B), washer (6B) and bracket (9B) following
the exact sequence shown in the figure. Start nut (4B) on the op-
posite side of bracket (9B) fully home, without tightening. Pre-fit
no.2 rubber elements (15B) on RH bracket (11).
3B
ISTR 974 / 00
11