MADRIX PLEXUS Handbuch Seite 43

MADRIX PLEXUS User Manual (English) 43
Important Information
When using Direct Remote Control, please be aware of other settings of the PLEXUS device.
Please pay special attention to the menu 'Network' > 'Art-Net'.
Art-Net -> DMX 1 and Art-Net -> DMX 2 specify if incoming Art-Net data is routed to the
corresponding XLR port (DMX 1 or DMX 2).
In this way, you can route incoming Art-Net data to the two XLR ports for output. But if you are
using Remote Control via DMX at the same time, you might use an XLR port for input and output at
the same time as a result. Please avoid such a configuration, because problems are very
likely.
DMX 1 -> Art-Net and DMX 2 -> Art-Net specify if the corresponding XLR port is used for DMX-IN
and if those incoming values should be broadcasted to the Art-Net network (Art-Net Remote).
As mentioned above, DMX-IN and Remote Control are two different features. If you are using
Remote Control and have DMX -> Art-Net activated as well, problems are very likely because the
Remote Control commands would be sent to the network as normal Art-Net data. Please avoid
such a configuration if not intended.
You may choose to create such a situation, for example when using Remote Control and having
configured Art-Net Stand-Alone (DMX data comes from the SD card and is sent to the Art-Net
network using this menu) or when using only 1 DMX universe. But please configure your DMX
Universes and DMX channels accordingly in order to avoid double usage of DMX channels.
© 2017 inoage GmbH