MADRIX PLEXUS Handbuch Seite 112

112 MADRIX 3 PLEXUS User Manual / Handbuch
'IP Address / defines the network settings regarding IP address, Subnet mask, and
Subnet Mask' standard gateway for the device.
On the device, use the menu 'Network' > 'IP Address'.
'Intensity' defines the main brightness of the output your device in percent. Applicable
values are: 0 - 100%. The default value is 100%.
On the device, use the menu 'Stand-Alone' > 'Intensity/Speed'.
'Speed' defines the tempo of the output in percent. Applicable values are: 1 -
1000%. The default value is 100%.
On the device, use the menu 'Stand-Alone' > 'Intensity/Speed'.
'Sync' defines if your interfaces, who are in the same Group, use the implemented
Master-Slave Synchronization.
On the device, use the menu 'Network' > 'Sync'.
More information is provided under Master-Slave Synchronization
Slave Synchronization
'Group' assigns your device to a certain group. In this way you may set up several
different Master-Slave clusters (in the same network). Make sure that
Master or Slave devices that should communicate with each other are
assigned to the same group!
On the device, use the menu 'Network' > 'Sync'.
More information is provided under Master-Slave Synchronization
Slave Synchronization
'Clock defines the time and date of the device.
(Date - Time)' On the device, use the menu 'Settings' > 'Clock'.
'Location' defines the geographical location of the device, incl. the time zone. This
information is required to calculate the corresponding sunrise and sunset
times.
On the device, use the menu 'Settings' > 'Location'.
below.
below.
Master-
Master-
© 2017 inoage GmbH