List Of Functions - MADRIX PLEXUS Handbuch

38 MADRIX 3 PLEXUS User Manual / Handbuch
Remote control via Art-Net means that you will connect an Art-Net unit to the Ethernet port of
the PLEXUS. Both XLR ports will then be available for DMX-OUT (output).
Settings Of The Device
Navigate to the menu 'Remote Control' > 'Remote Options'.
'Receive Via' - Specifies the source of remote commands. You can choose to receive remote
commands via DMX, via Art-Net, or to turn remote control off.
'On Port/On Universe' - Specifies for DMX which XLR port is used (DMX 1 or DMX 2) or for Art-
Net which universe is used to send the remote commands (1 to 256).
'Start Channel' - Specifies a DMX start channel (1 to 512). It defines the range of DMX channels
used for the set of remote functions. 20 DMX channels are used by the remote functions. The
default value is 1.
'DMX -> Art-Net' - Specifies if DMX-Thru is enabled, when Remote Control is activated over DMX.
Incoming DMX data would then additionally be sent through to Art-Net.
You may change the settings in this menu, on the device (How To Edit Values).
You can also configure the settings in the PLEXUS Configuration window in MADRIX. For more
information, see Managing Devices Further.

List Of Functions

This list includes all available remote functions and describes their functionality. Most of these
functions are self-explanatory and have been described in the various PLEXUS menus.
The following DMX channels are based on the default 'Start Channel' with a value of 1. If you
would like to use a different Start channel, the DMX channels will change accordingly.
© 2017 inoage GmbH