MADRIX PLEXUS Handbuch Seite 18

18 MADRIX 3 PLEXUS User Manual / Handbuch
Freeze
Please note: You may reset the DMX value to its default value by
pressing ' or ' at the same time for 2 seconds.
You may change the settings and the functionality. Press and hold 'OK'
for 2 seconds.
'Send Via' - Choose between the XLR ports ('DMX') and the Art-Net port
('Art-Net').
'Send On Universe/Send On Port' - Choose the first or second DMX
universe ('1', '2') or the Art-Net universe (1 - 256), respectively.
'Show Values As' - Choose between decimal values ('Decimal'),
hexadecimal values ('Hexadec.') or percentage values ('Percent').
'Test Mode' - Choose between three modes ('Channel', 'Universe', 'All
Channels'). Channel allows you to quickly change the DMX channels,
while the value will be saved and stays at the level you specified. All
other channels will be set to 0. Universe allows you to set up every
single channel with different values. The device will save the value for
each channel individually. All Channels will allow you to set up a DMX
value that is send to all channels of the DMX or Art-Net port.
Navigate to the menu 'Tools' > 'Freeze'.
You can freeze/halt DMX output on all ports (i.e. connections) using
this menu. This will use and display only the last frame that was active.
Meanwhile, playback or input may continue. In this way, freeze does
not function as Play/Pause.
If you activate Freeze and leave this menu, freeze will still be active. It
will be shown in the menu bar with a blinking icon, as described above.
Press either , , , or
'FREEZED' will be displayed.
Press either , , , or
'Running' will be displayed again.
to halt the output. When freeze is activated,
a second time to start data output again,
© 2017 inoage GmbH