MADRIX PLEXUS Handbuch Seite 21

DMX
Display
© 2017 inoage GmbH
Navigate to the menu 'Settings' > 'DMX'.
You can choose to activate or deactivate sending Full Frames.
- Per DMX512 standard, a device only sends the number of DMX
channels that is configured. For example, if you are using 312 DMX
channels on a DMX universe, only 312 DMX channels will be sent with
every single frame on this universe.
- By default, Full Frames are deactivated for 'DMX 1' and 'DMX 2'. When
activated, the device will always send full frames on a particular
universe, instead of optimized frames. Sending full frames means that
always the full 512 DMX channels of a DMX universe will be sent with
every frame [even when you are using less than 512 channels].
- By default, Full Frames are deactivated for Art-Net 'Art-Net 1' and
'Art-Net 2'.
- Activating Full Frames is recommended if problems with the data
output on your LEDs occur.
Navigate to the menu 'Settings' > 'Display'.
You can specify various settings of the display in this menu.
'Brightness On' - specifies how bright the display is, when it is used.
Applicable values are: 10 - 100%. The default value is 100%.
'Brightness Dimmed' - specifies how bright the display is, when it gets
dimmed. Applicable values are: 0 - 100%. The default value is 10%.
'Dim After' - specifies after how much time the display will be dimmed.
The default value is 30s.
'Contrast' - specifies the how well the display can be read. Applicable
values are: 0 - 100%. The default value is 50%.
'Invert' - specifies if the colors of the display will be inverted, or not.
Black background and a white font are the default settings.
You may change the settings in this menu, on the device
Values).
You can also configure the settings in the PLEXUS Configuration window
in MADRIX. For more information, see
MADRIX PLEXUS User Manual (English)
Managing Devices
21
(How To Edit
Further.