MADRIX PLEXUS Handbuch Seite 120

120 MADRIX 3 PLEXUS User Manual / Handbuch
More Information
You don't need to configure Timers for your Slave devices, when the Master-/Slave-
Synchronization should be used. Only the Master interface needs to have Timers configured (if
you wish to use Timers). The Master will automatically communicate the Timer(s) to the Slave
device(s). You can configure Timers in the
When using Master-/Slave-Synchronization that means you are going to use more than 1
PLEXUS interface. Please make sure to record
Converting Files) that are set up correctly for all of your devices (regarding size of your Patch/
virtual LED matrix and DMX Universe output, for example).
Intensity Group is a feature that can be used in combination with
When setting up the Sync mode, it is important to pay attention to the Group settings as well.
Please continue with the next chapter Group.
Group
Call up the PLEXUS Configuration window again. Go to the menu 'Tools' > 'PLEXUS Configuration
' (or 'Ctrl+Alt+P').
Select your device in the list. Change the settings for every required device, each at a time.
Please configure the column 'Group'!
The setting assigns your device to a certain group. In this way, you may set up several different
Master-Slave clusters (in the same network). It allows you to create several, independent groups.
Make sure that Master or Slave devices which should communicate with each other are assigned
to the same group!
PLEXUS Configuration
(Step 4) Recording) and convert effects
window.
Remote Control.
© 2017 inoage GmbH
(Step 5)