MADRIX PLEXUS Handbuch Seite 100

100 MADRIX 3 PLEXUS User Manual / Handbuch
'Soft Loop' creates an automatic loop by the software. First, enter a number of frames.
MADRIX will add these frames to the end of the Scene and therefore loops
towards the first frame of your Scene. A cross-fade is created. For example, if
your record was set to a frame rate of 33 FPS and you enter 66 here, two
seconds will be used for a loop towards the first frame.
'Follow defines which Scene will be played after the currently selected Scene. Applicable
Scene' values are: 'No', 'Next', and a specific Scene ('1', '2', '3', etc).
'Intensity' defines the brightness for the Scene in percent. Applicable values are: 0 - 100.
'Speed' defines the tempo in percent. Applicable values are: 1 - 1000.
'Port 1' defines if Port 1 of the extension port will be triggered when the Scene begins to
play. Applicable values are: 'NO', '0' (OFF), or '1' (ON).
'Port 2' defines if Port 2 of the extension port will be triggered when the Scene begins to
play. Applicable values are: 'NO', '0' (OFF), or '1' (ON).
'Port 3' defines if Port 3 of the extension port will be triggered when the Scene begins to
play. Applicable values are: 'NO', '0' (OFF), or '1' (ON).
'Port 4' defines if Port 4 of the extension port will be triggered when the Scene begins to
play. Applicable values are: 'NO', '0' (OFF), or '1' (ON).
'Port 5' defines if Port 5 of the extension port will be triggered when the Scene begins to
play. Applicable values are: 'NO', '0' (OFF), or '1' (ON).
'Port 6' defines if Port 6 of the extension port will be triggered when the Scene begins to
play. Applicable values are: 'NO', '0' (OFF), or '1' (ON).
'Port 7' defines if Port 7 of the extension port will be triggered when the Scene begins to
play. Applicable values are: 'NO', '0' (OFF), or '1' (ON).
© 2017 inoage GmbH