MADRIX PLEXUS Handbuch Seite 15

MADRIX PLEXUS User Manual (English) 15
'Art-Net -> DMX 1' and 'Art-Net -> DMX 2' specify if incoming Art-Net
data is routed to the corresponding XLR port (DMX 1 or DMX 2) and
which Art-Net universe should function as source for each port. These
settings should be activated if you want to connect your MADRIX PC to
your PLEXUS device using network cables. In Live Mode, you would then
send data over the network to the PLEXUS and the PLEXUS outputs the
data to each XLR port, where your LED fixtures, LED controllers, or LED
drivers would be connected.
'DMX 1 -> Art-Net' and 'DMX 2 -> Art-Net' specify if the corresponding
XLR port is used and if those incoming values should be broadcasted to
the Art-Net network and to which Art-Net universe it should be sent.
This means, the PLEXUS runs a Stand-Alone show and the data is sent
over network (via Art-Net) directly to the LED fixtures or you could
convert the data to DMX again using a signal converter. Data will be
sent over Art-Net to the configured Art-Net universe via Broadcast
according to the configured IP address and Subnet mask of the device.
This could also be data from "Test Sending" (see below).
You may change the settings in this menu, on the device (How To Edit
Values).
You can also configure the settings in the PLEXUS Configuration window
in MADRIX. For more information, see Managing Devices Further.
For more information about Art-Net output, see the chapter Art-Net
(Output).
Sync Navigate to the menu 'Network' > 'Sync'.
This menu shows the current settings regarding Master-Slave
Synchronization.
© 2017 inoage GmbH