Status; Configuration - Multiplex WINGSTABI Erweiterte Anleitung

Status

The bottom item in the menu bar "Status" is by no means the least important; this is
where you can receive all information relating to the connection between your
WINGSTABI and the transmitter. You can observe the functions of the RC and gyro
channels displayed graphically and read out all values as numbers. Bear in mind here
that the transfer from the WINGSTABI via Bluetooth will not be as fast as the USB
interface on the PC.
Figure 29: Status reports about
the WINGSTABI connection
The "Delete error memory", "Restart the WINGSTABI" and "Firmware update" functions
can be found beneath the tiny symbols on the right in the operating status bar. It is best
that the latter is performed with the PC via USB, due to the low transmission speed via
Bluetooth.

Configuration

Configuration usually takes place on the PC, divided here into model and servo settings
as well as receiver and sensor. Please note that the app does not have two levels,
separated into "Basic" and "Advanced". All menu items are still available, of course with
the same descriptions.
Seite 37/39