Multiplex WINGSTABI Erweiterte Anleitung Seite 71

In the controller menu, set the trim for ailerons, elevator and rudder under "Step" to off.
Now perform the basic configuration of the WINGSTABI in the MULTIPLEX launcher
using the assistant. Then the output of the WINGSTABI sensor values / telemetry is
activated. To do this, click the antenna symbol => and then "Telemetry". Under
"Telemetry transfer", select PROFI TX (this will activate the extended telemetry
displays). Assign the sensor addresses for the sensitivity and the status messages as
desired. Save the setting using the flashing arrow in the WINGSTABI.
Finally, click the antenna symbol again. Here, you need to activate the trim channels for
the aileron trim, elevator trim and rudder trim.
!
IMPORTANT NOTE: If you have defined trim channels (one is sufficient) in the
WINGSTABI, you may under no circumstances continue to use the trim flight
and trim transfer options via fast switch.
Figure 24: PROFI TX telemetry settings
Seite 32/39