Reely MAMMOTH PRO RTR Bedienungsanleitung Seite 38

2 D
ESCRIPTION OF THE MODEL
Spindle
The axis onto which the wheel is screwed and around which the wheel turns.
Starter cord
With recoil spring to start the engine manually. It turns the crank shaft and therewith the piston via the piston rod, thus the
engine
Steering knuckle arm
Lever on the axle leg (steering lever). Moving the steering link via this lever towards the right or left causes the wheels to
swivel in.
Steering knuckle pin
Steering axle of the wheel. Connects the axle leg so that it is rotary with the axle leg support (between the top and bottom
transverse control arm).
Steering link
Generally consists of three flexible interconnected levers. The outer steering links (adjustable in length with adjustable
alignment) connect the steering knuckle arm at the axle leg so that it is rotary with the middle steering link part, which is
tilted right / left by the steering servo lever.
Steering link lever (=steering lever)
Lever on the axle leg. Moving the steering link via this lever towards the right or left causes the wheels to swivel in.
Steering servo
Servo-motor, that carries out mechanical control functions via a lever.
This servo effects steering via the steering links. A servo saver integrated in the servo control lever protects the servo from
damages, which can cause strong shocks against the wheels via the steering links at the servo transmission.
Throttle/brake servo
This servo controls the slide carburettor as well as the disk brakes
Throttle stop screw
Regulates the minimum air supply to the carburettor in idle speed
Toe-in block
Rear support of the bottom transverse links. Depending on the hole distance, the transverse links are situated at an angle
(toe-in) or parallel to the longitudinal axis of the vehicle.
Transverse link
Half axle transverse to the direction of motion, connects the wheel suspension (spindle, axle leg and steering knuckle pin)
with the chassis.
Trim
To fine tune the neutral position of the servo. The trim is superposed by the turns of the remote control lever.
Thus, the neutral position of the servo can be switched in one direction or the other.
38
Operating Instructions 4WD Monster Truck Chassis Item No. 23 32 35