4Wd Monster Truck Chassis - Reely MAMMOTH PRO RTR Bedienungsanleitung

2 D
ESCRIPTION OF THE MODEL
2.2
4WD M T C
ONSTER RUCK HASSIS
2/4 WD
2/4 Wheel Drive driven by 2 or 4
wheels.
ABC assembly
ABC means "Aluminum", "Brass" and
"Chrome". Aluminum with its small
thermal expansion and small weight
serves as material for pistons, the
cylinder is made of brass with chro-
me-plated contact surface.
Air filter
The air filter is made of foam and pre-
vents the penetration of dust and dirt
particles through the suction hole into
the carburettor and in the engine.
Alignment
Position of the wheel level to the dri-
ving direction:
a) Toe-in – Wheels point inwards
b) Toe-out – Wheels point outward
a b
Axle leg
This is where the axle turns. The
steering levers are located on the
front axle legs.
Bumper
made of aluminium, reaches far up,
������������
�����������
with screwed on aluminium cross-
ties and plastics supports for an ideal
dampening in the event of a frontal
crash.
Chassis
The "frame" of the vehicle, to be precise, only the bottom support plate.
CVD drive shaft
A shaft which on one side engages the attachment on the differential with a steel pin and which on the other side is connected
to the axle without tolerance via a cardan joint, leading to low wear.
In this way the wheel can turn even at a great steering angle (strongly angled shaft).
Damper plate
The upper end of the shock absorber of an axle right and left is screwed to the damper plate at the front or at the rear.
The shock absorbers are thus somehow interconnected via the damper plate.
Differential
Differential gear. Equalizes the different revolution speeds, e.g. between the wheel on the inside of a bend and the outside of
a bend.
36
Operating Instructions 4WD Monster Truck Chassis Item No. 23 32 35