Putting The Rc System Into Operation - Reely MAMMOTH PRO RTR Bedienungsanleitung

3 P
REPARATION
3.4
S
TARTING THE
- Remove lid of battery compart-
ment on the lower side of the
transmitter.
- Insert 8 AA (rechargeable) batte-
ries in the compartment,
observe the correct polarity!
- Close the lid again
- Place the battery support with the
cables and the plug in the RC-box
again.
- Carefully connect both red plugs.
- Push the lower end of the antenna
guiding tube into the outlet of the
antenna wire.
- Fasten the antenna wire on the
top at the guidance tube, by
wrapping adhesive tape around it
or by placing a rubber cap.
Do not shorten the antenna!
- Carefully close the receiver box.
- Make sure that the latch is properly
locked in place.
© REELY 01/07
RC I
NSTALLATION
- Open RC-box on the chassis
and
- remove the battery support
of the RC-box.
- Rremove the receiver
- Unwind the wire of the antenna
Also make sure that the cover
can still be opened easily after
fixing the antenna wire to enable
a change of the rechargeable bat-
teries.
- Switch the transmitter on.
The blue LED in the leg of the
transmitter should light up.
If the LED does not light up, check
batteries /rechargeable batteries
and replace them, if necessary.
- Place 4 AA batteries (rechargeable
batteries) in the support.
- Observe correct polarity
and tightness.
- Guide the antenna wire outwards
through one of the openings in the
cover of the RC box.
- Guide the antenna of the receiver
through the antenna guiding tube
- Switch on the receiver with the
switch on the RC-box.
The servos must turn in neutral
position.
Always switch ON the transmitter
first then the receiver.
First switch OFF the receiver,
then the transmitter.
41