Tools And Auxiliaries, Check List; Checking Alignment And Tooth Backlash Of Drive - Reely MAMMOTH PRO RTR Bedienungsanleitung

3 P
REPARATION
Monster Truck MAMMOTH Pro is pre-assembled ready to drive (Ready To Run).
Before the first start, some basic adjustments must be carried out or checked and the necessary
accessories and auxiliaries must be prepared.
Go through the various points of the check list one after the other, and your model is then ready to run.
3.2
T
OOLS AND AUXILIARIES
T
OOLS
- Socket wrench (or flat wrench) 7 mm
- Flat wrench 5 mm and 5.5 mm
- Allen wrench 2 mm and 2,5 mm
- Phillips head (Ph Nr. 1)
A
UXILIARIES
- Cable fastener
- Low viscosity machine oil for the air filter,
for lubrication and to protect the combustion
chamber against corrosive residues in the engine,
after operation („After Run")
The instructions specific to position front / back / right / left
always refer to the longitudinal axis of the vehicle
3.3 C
HECK ALIGNMENT AND TOOTH BACKLASH OF DRIVE
The engine transmits its power via the pinion on the clutch bell to the two main pinions of the two-speed drive, which are con-
nected with a one-way bearing. Both rotary axes, i.e. the crank shaft, engine-sided, and the axis of the drive section to the
front and rear axis, must be aligned so that they are exactly in parallel. This prevents tensions in the drive section, premature
wear of the pinions and bearing journals as well as loss of power.
The parallel alignment of crankshaft and drive section must be checked every time before using the vehicle
and, if necessary, must be readjusted!
When the alignment is in parallel, the pinion on the clutch bell and the main pinion will run smoothly.
If there is too much play, this will destroy the toothed wheels in the long run; too little play destroys the bearing in clutch
and engine.
The tooth backlash should be checked for both pinions on the clutch bell and on the transmission.
Checking the tooth backlash
- Insert a thin strip of paper both between the pinions on the
clutch bell and between the main pinions of the two-speed
transmission in the drive section.
- Turn gears by hand;
the paper strips must not rip apart when the wheel
turns!
Readjusting
- Unscrew four screws of the engine mount fastener on the
lower side of the the mounting plate (chassis)
- Align engine laterally and fasten screws again tightly
- Unscrew four screws, at the top, on the engine support
and adjust the engine lengthwise
40
,
CHECK LIST FOR PUTTING INTO OPERATION
NOTE!
in drive direction "forward"!
C
HECK LIST FOR PUTTING INTO OPERATION
What must be done:
- Check alignment and tooth backlash of drive
- Function control of servos
- Check the range of the remote control transmitter
- Check basic carburettor setting
- Screw in glow plug
- Fill in model fuel
P
- Let engine run
Operating Instructions 4WD Monster Truck Chassis Item No. 23 32 35