Lenze 8200 vector Montageanleitung Seite 71

Show/Hide Bookmarks
Safety instructions
1
5. Electrical connection
When working on live controllers, the valid national regulations for the prevention of accidents (e. g. VBG 4) must
be observed.
The electrical installation must be carried out in compliance with the corresponding regulations (e.g. cable
cross-sections, fuses, PE connection). Additional notes and information can be obtained from the corresponding
Instructions.
The Instructions contain notes concerning wiring according to EMC regulations (shielding, earthing, filters and cable
routing). These notes must also be observed when using CE-marked controllers. The compliance with limit values
required by the EMC legislation is the responsibility of the manufacturer of the machine or system.
6. Operation
If necessary, systems including controllers must be equipped with additional monitoring and protection devices
according to the applying safety regulations (e.g. regulation for technical equipment, regulation for the prevention
of accidents). The controller can be adapted to your application. Please observe the corresponding information given
in the Instructions.
After a controller has been disconnected from the voltage supply, all live components and power connections must
not be touched immediately because capacitors can still be charged. Please observe the corresponding stickers on
the controller.
All protection covers and doors must be shut during operation.
Note for UL-approved systems with integrated controllers: UL warnings are notes which only apply to UL
systems. The Instructions give UL-related information.
7. Safe standstill
The variant V004 of 9300 and 9300 vector, and the variant Bx4x of 8200 vector controllers support the function "Safe
standstill", protection against unexpected start, according to the requirements of Annex I No. 1.2.7 of the EC Directive
"Machinery" 98/37/EG, DIN EN 954-1 category 3 and DIN EN 1037. Please observe the notes on the function "Safe
standstill" given in the corresponding Instructions.
8. Maintenance and service
Please observe the Instructions given by the manufacturer.
Please observe the product-specific safety and application notes in these Instructions.
L
5
EDK82EV222 DE/EN/FR 6.0