Lenze 8200 vector Montageanleitung Seite 116

Show/Hide Bookmarks
Commissioning
7
Code table (excerpt)
Code
No. Name
C0105 Deceleration time
quick stop (QSP)
C0106 Holding time auto
DCB
C0107 Holding time DCB 999.00 1.00
C0111 Configuration
v analog output
X3/62 (AOUT1-IN)
C0117 Fixed
v
configuration of
digital output A1
(DIGOUT1)
C0119 Configuration PTC
v v
input / earth fault input / earth fault
detection d i
50
Possible settings
Lenze Choice
5.00 0.00
0.50 0.00
= auto DCB not
active
-0- -0- Output frequency with slip
(MCTRL1-NOUT+SLIP)
-0- -0- Ready for operation (DCTRL1-RDY)
-0- -0- PTC input not
active
-1- PTC input active,
TRIP set
-2- PTC input active,
Warning set
-3- PTC input not
active
-4- PTC input active,
TRIP set
-5- PTC input active,
Warning set
EDK82EV222 DE/EN/FR 6.0
{s} 1300.00 Quick stop decelerates
{s} 999.00
= ∞
{s} 999.00
= ∞
Earth fault
detection active detection if it has been detection active
Earth fault
detection detection
d deactivated i d
IMPORTANT
the drive to standstill
according to the
deceleration time set
under C0105. If the
output frequency falls
below the threshold
under C0019, the DCB
will be activated
Holding time, if DCB is
activated because the
value falls below the
setting in C0019.
Holding time, if DCB is
activated via an external
terminal or control word.
See the Operating
Instructions for further
settings
6 V/12 mA C0011
≡
See the Operating
Instructions for further
settings
Deactivate the earth fault
detection if it has been
activated unintentionally i d i i ll
L