Lenze 8200 vector Montageanleitung Seite 117

Show/Hide Bookmarks
Code
No. Name
2
C0120 I t switch-off
C0140* Added frequency
setpoint
(NSET1-NADD)
C0142 Start condition
v v
C0143* Selection of
v v
flying-restart flying restart
C0144 No temperature
v
depending
chopper chopper
frequency
derating
L
Possible settings
Lenze Choice
0 0
= not active
-650.00
-0- Automatic start inhibited
-1-
Flying restart not active
-1- Automatic start, if X3/28 = HIGH
Flying restart not active
-2- Automatic start inhibited
Flying-restart circuit active
-3- Automatic start, if X3/28 = HIGH
Flying-restart circuit active
-0- -0- Max. output frequency (C0011) ... 0
Hz
-1- Last output frequency ... 0 Hz
-2- Frequency setpoint addition
(NSET1-NOUT)
-3- Act. process controller value
(C0412/5) addition (PCTRL1-ACT)
-0- No temperature depending chopper
-1-
frequency derating
-1- Automatic chopper frequency
derating at J
EDK82EV222 DE/EN/FR 6.0
Commissioning
Code table (excerpt)
{%} 200 Reference: Apparent
{Hz} 650.00 Application I/O supports
- 5 °C
max
7
IMPORTANT
motor current (C0054)
650 Hz as of version
E82AF ... XXVB21
Selection via function
l
j
of the keypad or
the parameter
channel
Non-volatile saving of
l
the value (i.e. active
after mains
switching); value is
added to the main
setpoint
Start after LOW-HIGH
level change at X3/28
Start after LOW-HIGH
level change at X3/28
Motor speed selected for
the indicated range the indicated range
The corresponding value
is input after controller is input after controller
enable.
51