Scheppach DP3000 Originalbetriebsanleitung Seite 42

15. ' L VSRVDODQ G UHF\ F OLQ J
1RWHVIRUSDFNDJLQ J
The packaging materials are recy-
clable. Please dispose of packaging
in an environmentally friendly man-
ner.
16. 7UR X E OHVKRRWL Q J
The following table shows fault symptoms and describes remedial measures in the event of your product failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault 3RVVLEOHFDX V H
Engine does not start. Spark plug connector unplugged.
Contaminated spark plug.
No fuel or old fuel.
Choke not in open position.
Fuel line clogged.
Engine flooded.
Engine runs errati- Spark plug connector loose.
cally.
Engine running in choke position.
Fuel line clogged or old fuel.
Ventilation blocked.
Water or contamination in the fuel
system.
Incorrect carburettor setting.
Motor is overheated. Engine oil level low.
Contaminated air filter.
Airflow restricted.
Carburettor not adjusted correctly.
The machine does not The gear was not chosen correctly.
move when the engine
is running.
42 | GB
<R X F D Q ¿ Q G R X W KR Z W R GLVSR V H R I W K H GLVXVH G
GH Y L F H I U R P \ R X U OR F D ODXW K R U L W \ R U F L W \ DGPLQLV
WUDWLR Q
) X H OVDQ G RLOV
• Before disposing of the device, the fuel tank and
the engine oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in an
environmentally friendly manner.
Remedy
Re-connect the spark plug cable to the spark plug.
Clean, set gap or replace.
Fill with clean, fresh petrol.
The choke lever must be positioned in the choke ON
position during cold starting.
Check the fuel line for kinks or damage.
Wait a few minutes before restarting.
Connect and fasten the spark plug cable.
Set the choker-arm to OFF.
Fill the tank with clean, fresh petrol.
Clean the air filter.
Empty the tank. Fill the tank with fresh fuel.
Contact the service department.
Top up the oil.
Clean or replace the air filter.
Remove and clean the housing.
Contact the service department.
Shift the shift lever to the correct shift position.
www.scheppach.com
-