Scheppach DP3000 Originalbetriebsanleitung Seite 38

• Always work slowly and with increased attention.
Always guide the machine in an upward or down-
ward direction. Never work at an angle on a slope.
The machine can become unbalanced and tip over.
The machine must not be used on slopes steeper
than 20%. Take care that the machine does not tip
over - danger to life!
• Remember that even if the unit has four-wheel
drive, you must be careful when working in adverse
weather conditions (ice, heavy rain and snow) or
on types of ground that may cause the dumper to
become unstable.
• Please note that this is a wheeled vehicle that is
subject to considerable pitching movements when
driving over bumps, holes and steps.
10.12 6ZLWFKLQ J R‡ WKHHQ J LQ H
m � $ W W H Q W L R Q �
If you need to stop the engine in an emergency, turn
the on/off switch (2) to the OFF position.
Use the following procedure under normal conditions:
1. Set the throttle lever (1) to the "L" position.
2. Let the engine idle for a minute or two after fin-
ishing work.
3. Turn the on/off switch (2) to "OFF".
4. Close the fuel valve (23).
5. If you leave the machine unattended, disconnect
the spark plug connector (29) from the spark plug
to prevent accidental starting of the machine.
& $ 8 7,21
Do not adjust the choke lever (24) to stop the engine.
Misfiring or engine damage may occur.
11. 7UDQ V SRUW
m : $ 5 1,1*
' D QJH U R I LQM X U \
Unintended and unexpected start-up of the product
may lead to injuries.
- After loading, switch off the engine and, after the
engine has cooled down, remove the spark plug
connector from the spark plug.
- The product can cause severe crushing injuries
due to its own weight.
Allow the engine to cool down before transporting or
loading to avoid burns and to prevent fire hazards.
When transporting over longer distances, drain the
fuel tank completely.
Secure the machine on the transport vehicle against
rolling, slipping or tipping over and also lash down the
dumper.
38 | GB
12. & O HDQ L Q J DQ G PDLQ W HQ D Q F H
m : $ 5 1,1*
' D QJH U R I LQM X U \ DQGEXU Q LQJ
The product can start unexpectedly and cause inju-
ries. In addition, temperatures of 80° C and more can
be reached.
- Switch off the motor before carrying out any clean-
ing or maintenance work.
- Allow the motor to cool down.
- Remove the spark plug cable from the spark plug.
m : $ 5 1,1*
+ H D OW K KD] D U G
Inhaling petrol/lubricant vapours may lead to severe
health damage, loss of consciousness and, in ex-
treme cases, to death.
- Do not inhale petrol/lubricant vapours.
- Operate the product outdoors only.
NOTE!
5L V N RIGD P D J H
Water entering the housing can cause engine dam-
ages. In addition, the jet of a high-pressure cleaner
can damage parts of the product.
- Clean the product with a cloth, hand brush, etc.
- Do not immerse the product in water or other liquids
and do not spray it with a high-pressure cleaner.
Maintenance plan
Check for servicing
Loose screws
Check for damage
Check fuel tank for leaks
Check tire pressure
Clean machine
Clean the spark plug
Clean the air filter
Check the oil level
Lubricate drive chain
Change gear oil
12.1 & K HFNWLUHSUHVVX U H
• Check the tyre pressure regularly. Long standing
times and sunlight contribute to rapid ageing of the
tyres.
• Recommended tyre pressure on all wheels:
2.1 bar (0.21MPa)
www.scheppach.com
Interval
Before commissioning
Before commissioning
Before commissioning
Before commissioning
After commissioning
Every 10 operating
hours
Every 10 operating
hours
Every 50 operating
hours
Every 500 operating
hours
Every 1000 operating
hours