HIKOKI Dust Extractor System Handhabungsanleitung Seite 11

TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
Symptom
The dust extraction performance
has declined, or dust is leaking out
of the dust extractor system.
The position of the nozzle won't
lock.
Possible cause
The dust box is full.
The fi lter box is clogged.
The fi lter, brush cap, or nozzle seal is
cracked, damaged, or worn out.
The following incorrect steps were
performed:
The nozzle was set to the desired
position
The nozzle adjustment button was
pressed
11
Remedy
Empty the dust from the dust box and
clean the dust box.
Clean the fi lter.
Or, replace the fi lter with a new one.
Replace it with a new one.
Perform the following steps:
While pressing and holding the
nozzle adjustment button...
Set the nozzle to the desired
position
Release the nozzle adjustment
button
English