Scheppach HBS30x Originalbetriebsanleitung Seite 39

15. Troubleshooting
Fault Possible cause
Motor, cable or plug defective,
fuses burnt
Motor does not work
Housing cover open (limit switch)
The motor starts
up slowly and does Voltage too low, coils damaged,
not reach operating capacitor burnt
speed.
Motor makes exces-
Coils damaged, motor defective
sive noise
The motor does not Circuits in the network are over-
reach its full power. loaded (lamps other motors, etc.)
Motor overheats Overloading of the motor, insuffi-
easily. cient cooling of the motor
Saw cut is rough or Saw blade dull, tooth shape not ap-
wavy propriate for the material thickness
Workpiece pulls Excessive cutting pressure and/or
away and/or splinters saw blade not suitable for use
Guide has been wrongly set
Saw blade is not
running straight
Wrong saw blade
Blunt saw blade
Burn marks appear
on the wood during
the cutting work Wrong saw blade
Blunt saw blade
Saw blade jams Deposits on the saw blade
during cutting work
Guide has been set poorly
Remedy
Arrange for inspection of the machine by a
specialist. Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Close housing cover exactly
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a
specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the
same circuit
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal
cooling of the motor
Resharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade
Set the saw blade guide according to the operating
instructions
Select a saw blade according to the operating
instructions
Change the saw blade
Select a saw blade according to the operating
instructions
Change the saw blade
Clean the saw blade
Set the saw blade guide according to the operating
instructions
www.scheppach.com GB | 39