Scheppach HBS30x Originalbetriebsanleitung Seite 27

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
we hope your new tool brings you much enjoyment and
success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regulations
and VDE regulations 0100, DIN 57113 / VDE0113.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the user
to become familiar with the machine and take advan-
tage of its application possibilities in accordance with
the recommendations.
The operating instructions contain important informa-
tion on how to operate the machine safely, profession-
ally and economically, how to avoid danger, costly re-
pairs, reduce downtimes and how to increase reliability
and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information.
The machine can only be operated by persons who were
instructed concerning the operation of the machine and
who are informed about the associated dangers. The
minimum age requirement must be complied with.
In addition to the safety requirements in these oper-
ating instructions and your country's applicable regu-
lations, you should observe the generally recognized
technical rules concerning the operation of woodwork-
ing machines.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions and
the safety information.
2. Device description (Fig. 1 - 1b)
1 Clamping screw
2 Top saw band roller
3 Rubber surface
4 Saw band guard
5 Top saw band guide
6 Table insert
7 Saw table
8 Table enlargement
9. Bottom saw band roller
10 Clamping lever
11 Foot
12 Cover locking mechanism
13 Side cover
14 Parallel stop
15 On/off switch
16 Locking screw for top saw band roller
17 Set screw for top saw band roller
18 Machine frame
19 Mains cable
20 Motor
21 Wing nut
22 Locking handle for saw table
23 Clamping plate
24 Extraction nozzle
25 Mitre gauge (optional)
26 Saw band
27 Adjustment handle for saw band guide
28 Locking handle for saw band guide
29 Push stick
30 Allen key 5 mm
31 Allen key 4 mm
32 Allen key 3 mm
33 Screwdriver
34 Open-ended spanner SW10/13
35 Degree scale for swivel range
36 Screw M6x35
www.scheppach.com GB | 27