Brompton P Line Bedienungsanleitung Seite 18

SETTING THE GEARS
• Insert the inner cable IC into the cable housing CH
• Thread it all the way through until it exits through the end of the housing
• Route the cable along the bike frame following the same paths as the existing cables. This is essential
for folding
• When the cable reaches the rear frame, route the cable through the stopping block (fig. 11)
• Using some needle nose pliers or similar, pull the cable through the housing and insert into the derailleur
• Tighten the bolt that holds the cable in place on the inside of the derrailleur (fig. 8)
• Use the barrel adjuster on the shifter to make adjustments to the cable tension as needed (fig. 10)
• Unscrewing the adjuster will add more tension to the cable and improve shifting into the lower gear
(fig. 10)
• Screwing the adjuster inwards will reduce tension and improve shifting into the high gear
• The jockey wheel on the derailluer needs to be in-line with the selected gear sprocket on the cassette
(fig. 10).
Fig. 11
18
SB
GC