Brompton P Line Bedienungsanleitung Seite 17

LIMIT SCREWS - The limit screws LS operates in the
same way they would on the traditional gearing system. These
are used to set the limits on how far inwards or outwards
the derailluer can carry the chain. If there is an issue with
reaching the highest or the lowest gear, the limit screw may
need adjusting.
CABLE ENTRY HOLE
SHIFT LEVER
FITTING A NEW CABLE
• Screw the barrel adjuster fully clockwise so that it is at its shortest setting, then unscrew by 2 turns
• Select the lowest gear (1) and then press the shift lever downward so it does not obscure the cable
entry hole
• Feed the gear cable into the shifter in a slightly downward direction and through the cable bush
• If there is resistance pushing the cable through the bush pull the cable back a little and try again
• Once you can feel the cable pass through the bush keep feeding it until you feel slight resistance
• Keep feeding it through so that it follows around the guide inside the shifter and exits through the barrel
adjuster.
DO NOT FORCE THE CABLE AS THIS MAY DAMAGE THE SHIFTER
C
CABLE BUSH
INWARDS
BARREL ADJUSTER
17
LS-2
LS-1 is used to create alignment on the
largest sprocket on the cassete. LS-2
for the smallest (fig. 8).
Fig. 10
GUIDE
OUTWARDS
LS-1
D
Fig. 9