Angelo Po 06WFR3GD Bedienungsanleitung Seite 54

ENGLISH
Lighting
Operate the appliance's master switch to
1)
connect it to the electrical mains. The mains
light (P) comes on.
Turn on the gas supply tap.
2)
Press key (B) to set the appliance in "stand-
3)
by" mode. The mains power on light (P) goes
out and the display (A) shows the screen
shown here.
Press and turn the knob (L) anti-clockwise
4)
(pos. 3) to turn on the pilot light. Hold the
knob down for approximately 15 sec to start
up the thermocouple.
Press and turn the knob (L) anti-clockwise
5)
(pos. 4) to turn on the burner.
Press the key (B) to switch on the appliance
6)
and start the cooking cycle. The cooking
temperature set will appear in red on the dis-
play (A).
Turning off
Keep the key (B) pressed for about 6 seconds
1)
to stop the cooking cycle and switch the ap-
pliance off . The mains light (P) goes out.
Press the knob (L) and turn it clockwise (pos.
2)
5) to turn off the burner. The pilot light will
remain on to allow the burner to be re-lit.
Press the knob (L) and turn it clockwise (pos.
3)
6) to turn off the pilot light.
Turn off the gas supply tap.
4)
Cut off the mains electricity supply using the
5)
appliance's master switch.
22
SWITCHING THE APPLIANCE ON AND OFF
USE AND OPERATION
B
P
C F
3
L
6
A
G D
4
L
5
3019703_ut_GB