Angelo Po 06WFR3GD Bedienungsanleitung Seite 189

REPLACING PARTS
es which might cause unexpected hazards and
damage to people's health and safety if acti-
vated. Also make sure that during the mainte-
nance procedure, that the operator is always
able to check whether the plug is disconnect-
ed from the power outlet. If worn parts have to
be replaced, use original spare parts only.
To carry out this operation, proceed as follows.
Turn off the gas supply tap
1)
Open the hatch (A).
2)
Remove the guard (B).
3)
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Open the hatch (A).
2)
Unscrew the union (B).
3)
3019703_inst_GB
REPLACEMENT OF THE BURNER NOZZLE
REPLACEMENT OF THE PILOT LIGHT INJECTOR
The manufacturer declines all responsibly for
injury or damage to components due to the
use of non original parts, or extraordinary
work on the appliance which may modify the
safety requirements without the manufac-
turer's authorisation. When ordering compo-
nents, follow the instructions provided in the
parts catalogue.
Unscrew the nozzle (C) and replace it with
4)
the one suitable for the type of gas in use
(see table at back of manual).
Replace the guard (B).
5)
Close the hatch (A).
6)
Remove the nozzle (C) and replace it with the
4)
one suitable for the type of gas in use (see ta-
ble at back of manual).
Screw the union (B) back in place and close
5)
the hatch (A).
ENGLISH
17