Put The Station Out Of Operation; Dismantle The Station - Ecolab Inspexx S Betriebsanleitung

13.2

Put the station out of operation

Flush the station
1.
Empty the station
2.
13.3

Dismantle the station

DANGER!
Troubleshooting faults in the electrical system
Danger to life through contact with live components.
Electrical hazards are identified using the symbol shown here.
– Work on live components must be carried out only by skilled personnel who
are duly trained and authorised.
– Before starting work, isolate the system from the power supply and ensure
this state is maintained for the duration of the work.
– Housings and all other electronic components may be opened only for
start-up, maintenance and fault elimination purposes.
– Do not bypass safety guards and fuses.
– Check that there is no voltage; earth and short-circuit the station if
necessary.
– Cover and protect adjacent parts that are under voltage.
– Turn off the voltage supply immediately and organise repairs if there is any
damage to the insulation.
– Never bypass or deactivate fuses.
– When replacing fuses, use replacements with the same rating.
– Do not expose live parts to moisture, as this may cause short-circuits.
Dismantle the station in reverse order:
Dismantle the suction line
1.
Dismantle the water connections
2.
Decommissioning, disassembly, environmental protection
Ä Chapter 9.2.1 'Flush the station' on page 56
Ä 'Empty metering pump' on page 64
Ä Chapter 5 'Installation and assembly' on page 30
Ä Chapter 5.5 'Connect station' on page 34
85 MAN048969, Ver. 5-05.2024