Connect Station To The Disinfectant Supply - Ecolab Inspexx S Betriebsanleitung

Start-up
7.8

Connect station to the disinfectant supply

WARNING!
Burns caused by harmful chemical products
Contact with hazardous chemical products can cause severe burns.
– Read the enclosed safety data sheet carefully before using the chemical
product.
– The safety regulations and the required protective clothing for working with
chemicals must be complied with.
– Safety devices such as showers and eye flushing must be accessible and
checked regularly to ensure that they are fully functional.
– Ensure adequate ventilation and extraction.
– Avoid skin and eye contact.
WARNING!
Risk of injury caused by chemicals harmful to health
Corrosive chemicals can escape from tipped over chemical canisters causing
serious injuries from burns, and from falls on wet floors.
– Fit supplied canister brackets below the station on the wall.
– Always place chemical canisters in a canister holder to prevent them from
tipping over.
– Place a safety receptacle under the chemical canister to catch any
chemicals that may escape.
Requirements
Check the station for leaks.
n
Water supply closed.
n
The valve at the sampling point is closed.
n
A full disinfectant canister is ready.
n
Remove the water canister with the suction lance from the collection tray and put it
1.
down.
Place a full disinfectant canister in the canister holder and open it.
2.
Remove the suction lance from the water canister and insert it in the full disinfectant
3.
canister. Make sure that the suction lance cannot draw air.
MAN048969, Ver. 5-05.2024
Ensure that the collection tray is placed correctly under the canister
holder with the disinfectant canister.
46