D06Fh Pressure Reducer [Honeywell] - Ecolab Inspexx S Betriebsanleitung

To open the ball valve, turn the knob to a vertical position.
1.
Close the ball valve again after about 15 seconds.
2.
Clean or replace the fine filter
If necessary, the strainer cup and strainer can be cleaned.
NOTICE!
Damage to property due to unsuitable cleaning agents
Solvent-based and alcohol-based cleaning agents can cause water damage to
the pressure reducer.
– Do not use detergents containing solvents
– Do not use cleaning agents containing alcohol
Material:
Close the shut-off valve on the inlet side.
1.
Relieve the pressure on the output side, e.g. with a water tap.
2.
Close the shut-off valve on the outlet side.
3.
Unscrew the filter cup with the double ring spanner ZR06K.
4.
Take out the sieve, clean it and put it back in.
5.
Put the O-ring on the strainer cup.
6.
Screw the filter cup in hand-tight.
7.
Slowly open the shut-off valve on the inlet side.
8.
Slowly open the shut-off valve on the outlet side.
9.
9.5.2

D06FH pressure reducer [Honeywell]

Check pressure reducer
Close the shut-off valve on the outlet side.
1.
Check the back pressure with the pressure gauge at zero flow.
2.
If the pressure rises slightly, clean and maintain the pressure reducer.
3.
Slowly open the shut-off valve on the outlet side.
4.
If the sieves are very dirty, a longer rinsing time may be necessary.
Double ring spanner ZR06K
n
If damaged, replace the strainer.
59
Maintenance
MAN048969, Ver. 5-05.2024