Fault Rectification; Safety - Ecolab Inspexx S Betriebsanleitung

10

Fault rectification

10.1

Safety

WARNING!
Risk of injury due to unprofessional installation, maintenance and repair
work
Improperly performed installation, maintenance and repair work can lead to
serious injuries.
– Work may be carried out only by authorised and trained specialist
personnel.
– Before starting work, switch off the station and secure it against being
switched back on.
– If available, press one of the emergency stop buttons before starting work.
– Observe the safety data sheet for the chemical product used.
– Before starting work, disconnect the chemical supply and clean the station.
– Use only approved original spare parts.
WARNING!
Components and hoses under pressure
Components and hoses under pressure can move in uncontrolled manner and
cause injuries.
To ensure process safety:
– Close the shut-off valves of the pressurised media and, if possible, secure
them with a lock against unauthorised opening.
– Switch the station to a depressurised state.
– Wait until the standstill position is reached.
– Release connections only when depressurised.
– Ensure that no liquids escape unintentionally.
WARNING!
Risk of injury caused by chemicals harmful to health
Corrosive chemicals can escape from tipped over chemical canisters causing
serious injuries from burns, and from falls on wet floors.
– Fit supplied canister brackets below the station on the wall.
– Always place chemical canisters in a canister holder to prevent them from
tipping over.
– Place a safety receptacle under the chemical canister to catch any
chemicals that may escape.
Manufacturer documentation
In addition to the information in these operating instructions, observe
the manufacturer's documentation of the respective component.
71
Fault rectification
MAN048969, Ver. 5-05.2024