Shut Down Station Completely - Ecolab Inspexx S Betriebsanleitung

Requirements:
The water supply is closed.
n
A full disinfectant canister is ready.
n
Remove the empty disinfectant canister with suction lance from the canister holder
1.
and set it to one side.
Place the full disinfectant canister in the canister holder.
2.
Open the full disinfectant canister.
3.
Insert the suction lance in the new disinfectant canister. Make sure that the suction
4.
lance cannot draw air.
Stow the collection tray with disinfectant canister properly.
5.
8.5

Shut down station completely.

NOTICE!
In its gaseous form, the disinfectant is highly corrosive!
If the disinfectant solution remains in the proportional dosing unit permanently,
thedisinfectant can escape in gas form from the disinfectant solution and
damage the proportional dosing unit.
– If the station is not operated for more than 24 hours, flush the disinfectant
solution out of the proportional dosing unit.
Connect station to outflow.
1.
Flush the station.
2.
Stop work on the station.
3.
Ä Chapter 7.3 'Connect station to outflow' on page 41
Ä Chapter 9.2.1 'Flush the station' on page 56
Ä Chapter 9.3 'Complete service' on page 57
51
Operation
MAN048969, Ver. 5-05.2024