Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fitting and Installation
Connecting the hob to the gas supply
• If necessary, use a clamp to tighten and seal the connection
of the open end of the gas hose to the connector.
• Connect the supply line to the elbow (4) pre-mounted on the
gas inlet pipe (1) as shown in the illustration, fitting the con-
nection with a gasket.
1
Hob connection pipe
2
Nut
3
Gasket
4
Elbow,
1/2'' thread male gas
5
Gasket
6
Nut
7
Gas supply line
Connection sequence for conical connections:
• Cylindrical male adapter
• Seal, female gas adapter
• conical-cylindrical or cylindrical components
• Make the connection in such a way that no pressure is exerted
on the connection nuts and piping or the appliance is exposed
to any other pressure.
Make sure that the pipe cannot become blocked, kinked or
crushed or come into contact with sharp edges or hot areas,
both during and after installation (e.g. due to moving parts).
62
1
2
3
4
5
6
7
Werbung
