Werbung
Verfügbare Sprachen
Verfügbare Sprachen
After cleaning
• After cleaning, allow all components to dry completely before
reassembling them.
C aution!Dangerofburns
andriskofmalfunctions!
If the hob is operated with wet or damp components,
there is a risk of scalding and burns due to heated liquids
or the formation of steam or influencing the flames.
In addition, ignition of a cooking zone can be prevented,
e.g. by a damp ignition plug.
Only use completely dried components.
• Carefully reassemble all components, as described in the
section "Properties and configuration of the appliance" under
"Burner components" and, if applicable, refit the knobs includ-
ing the bearing rubbers.
C aution!Dangerofburns
andriskofdamage!
To avoid the dangers involved, do not use the hob again
until you have made sure that all components have been
assembled and positioned correctly.
This also applies to the correct and stable positioning of
the pot supports.
Cleaning and Maintenance of the Appliance
45
Werbung
