2.3.2 Wall Mounting
An optional wall mounting bracket kit is available, permitting the harsh enclosure to be mounted to a vertical
surface. Mount the wall brackets and terminal securely, to prevent the terminal from falling.
To wall mount the enclosure, follow these steps:
1 Bolt the two brackets to the bottom of the enclosure using the four M4 screws included with the brackets.
The brackets should be attached as shown in the figure below.
Figure 8: Wall-Mounting Brackets (left), Attached to Enclosure (right)
2 If the enclosure will be mounted above eye level, skip steps 3, 4, 5, 6 and proceed to step 7.
3 If the enclosure will be mounted at or above eye level, it will be necessary to reverse the front cover 180
degrees. To reverse the front cover, perform the steps 4 to 6.
4 Open the enclosure per the instructions provided in [Opening the Enclosure Page 14].
5 Loose and remove the two nuts securing the two grounding straps (that also operate as hinges for the front
cover) to the rear housing.
IND500x
Stud
Rear housing
Nut
Grounding strap
Front cover
Installation
15